$949.99
The MOVA S70 Roller combines maximum suction power of 30,000 Pa with a HydroForce™ mopping system that uses a continuous roller to vacuum, scrub and collect dirty water during cleaning. Its ultra-slim 90 mm design allows it to move under low furniture, while MaxiReach™ technology helps clean closer to walls and into corners.
Its 270 mm roller applies downward pressure of up to 4,700 Pa, or approximately 17 N, to tackle stubborn stains. After cleaning, the station automatically washes the roller with hot water at temperatures of up to 80°C to reduce manual maintenance.
The HydroForce™ system keeps the roller wet during operation to provide continuous floor washing. A spray system distributes water over the roller as it scrubs the surface and simultaneously collects dirty water.
This design helps limit the redistribution of previously collected dirt and keeps the cleaning surface fresher throughout the cycle.
The roller applies downward pressure of up to 4,700 Pa, or approximately 17 N, to help loosen dried-on residue, spills and embedded dirt.
Its 270 mm width allows it to cover a large surface area with each pass while distributing pressure across the full length of the roller.
The high-speed motor generates maximum suction power of 30,000 Pa to pick up hair, dust and debris from hard floors, carpets and crevices.
Its rubber brush helps lift particles while the suction system directs them into the dust bin.
At just 90 mm high, the S70 Roller can move under many sofas, beds and other pieces of furniture to clean hard-to-reach areas where dust and hair tend to accumulate.
Its integrated DToF sensor helps maintain this low-profile design while supporting the robot's navigation throughout its environment.
MaxiReach™ technology allows the mopping roller and side brush to extend outward to reduce missed areas near walls and baseboards.
The 27 cm roller can extend by up to an additional 4.4 cm to better follow edges, navigate around furniture legs and reach corners.
The S70 Roller uses a side brush designed to help limit hair buildup during cleaning. For environments where long hair and pet hair are particularly common, it is also compatible with the separately sold CleanChop™ 3.0 brush.
This optional brush is designed to cut hair during cleaning to reduce tangling around the main roller.
The station features a 5 L clean water tank to reduce the frequency of refilling when cleaning large areas. The system also collects dirty water separately in a 4.5 L tank.
According to MOVA, the system can cover a maximum area of up to 1,200 m² under specific testing conditions and when using the appropriate water-saving mode.
After a cleaning session, the station automatically washes the roller with water at temperatures of up to 80°C (176°F). The high temperature helps dissolve grease and residue accumulated on the cleaning surface.
The system also offers room-temperature, 45°C and 60°C washing settings to adapt roller cleaning to different levels of dirt.
The mopping roller can be raised by up to 12 mm, while the side brush can be lifted by up to 10 mm. This allows the robot to adjust its cleaning components according to the surface and selected cleaning mode.
The station handles roller washing after cleaning sessions and includes large tanks for clean and dirty water. A 3.2 L dust bag also helps reduce the frequency of routine maintenance.
Please note: The stated maximum performance figures, including 30,000 Pa of suction, 4,700 Pa of pressure, 1,200 m² of coverage and an 80°C washing temperature, are based on testing conducted under specific conditions. Actual results may vary depending on settings, room layout, surface type and environment.
